Part weight question

I’m almost done with printing my J MPCNC stuff, however when I weighed the XY_Burly part I decided to weigh it (mainly because it took 14hrs, 12 mins to print…) and it came out at 145g. I’m slightly concerned as I’m almost done and assumed the weight/filament usage was fine. However this single part alone is 50g less than what’s stated on the parts list, 50g is far too much to be a simple rounding error or even a conversion error (oz->g) anyone have this part sitting around they can put on some kitchen scales to check for me?

 

Thanks

What settings did you use for perimeters, top and bottom solid layers, fill %, and fill pattern, etc?

Also, what filament are you using? Don’t different brands have slightly different weights, and with that being the largest part by far, it should see the largest discrepancy.

I used Silver eSUN PLA+

Settings used:

0.8mm shell

2 walls with an extra wall every second layer

55% infill, grid pattern

 

Thanks