1st 3d print

Created gcode with IdeaMaker. Just a calibration cube. Started ok. Then went crazy. I am a complete nubie here. Any ideas?

You should probably try repetier with the settings I have laid out. With 3D printing so many things could be wrong.

#1 guess, way too fast. try no more than 30mm/s

1 Like

As it turned out my potentiometer were set way to hot. Now it is printing like a dream. I did slow it down some too. Thank you for your quick reply.

What potentiometer? The stepper drivers?

1 Like

Yes. The potentiometers on my drivers.