I’m trying to wire up my MPCNC using an Archim 1a board and I’m kind of getting close. However, I was trying to get the X1 and X2 steppers moving in the same direction but the E0 stepper controller doesn’t seem to want to do anything. I moved the cable to the E1 port and tried to move it in the Y axis and it moved the stepper so I know it’s not the stepper or the cable.
I know some extruder controllers won’t run if the thermistor isn’t reading a high enough value but why the E1 stepper works without that, I’m not sure.
I think I may have a bad board but I sure hope that’s not the case. Any ideas on how to debug/diagnose what’s going on with my E0 stepper controller would be greatly appreciated!
