Assembly - Bolts with no grip

ZenXY Troubleshooting
#1

So I printed everything for my V2 build. I went to assemble tonight and The first v-wheels seems not that snug, but may work out. They when to the last 2 on the trucks and 1 kind of tightened, the other had very little bite in the holes and would slip before you can tightened up the tension on the conduit… Ugh.

Last I checked the scaling/tuning of my printer were pretty accurate. Before I go down any rabbit holes… anyone experience these loose fits? I hate to have to reprint everything but I’m not sure I can add any “bite” to the current parts. Any thoughts appreciated.

#2

Wrap some tape around the nut to get the fit right. If you didn’t get your hardware from Ryan you may have got some that didn’t adhere to normal standards.

#3

I just printed my parts and have the same problem in some holes. I tried to add some super glue to the threads and let it dry to get a better grip, but it didn’t work. What I finally got working is shoving a toothpick point under the threads as I’m screwing in the bolt. Once the thread catches the toothpick, it provides enough bite to tighten.