I could use a little help please.
Last week I started looking at Estlcam. Today I decided to see if Estlcam could talk to my build. I have a Rambo with dual end stops and a full LCD. I also have a raspberry Pi hooked up running CNCjs.
Yesterday EVERYTHING was working just fine. After my adventures today during which I tried to run the Estlcam setup I bricked it all. Where it all went wrong was when I tried to run “Setup/CNC Controller/Program Controller”. Everything “seemed” to work but there was no machine movement. So I did a booboo and shut it all down rather than using the “Restore Controller” button in Estlcam. Now I have no LCD and no machine movement either from the LCD knob or through CNCjs even though CNCjs appears to be working without error.
Once I realized I shouldn’t have shut it down I figured it was too late and Id have to re-flash the Rambo. I tried the following firmware files:
Marlin-MPCNC_Rambo_T8_16T_LCD_DualEndstopby following this guide
The second one won’t compile and I get the following error:
Multiple libraries were found for "U8glib.h"
Not used: C:\Users\ronmillsap\AppData\Local\Arduino15\packages\rambo\hardware\avr\1.0.1\libraries\U8glib
fork/exec C:\Users\ronmillsap\AppData\Local\Arduino15\packages\arduino\tools\avr-gcc\4.9.2-atmel3.5.4-arduino2/bin/avr-gcc.exe: The filename or extension is too long.
Error compiling for board RAMBo.
Anybody have any ideas what I’m doing wrong?