CR10 to MPCNC

Hello!

I have an old CR10 3D Printer just sitting around and collecting dust, so I thought I would re-purpose this for a MPCNC. Has anyone done something like this before? I just plan on taking the motors, the power supply and the board. I know the the power supply and the motors will work but I am not sure if the board will work for the MPCNC. Would anyone know if the board will work?

Thanks!

Everything should work, the steppers might be a bit under powered but you won’t know until you try it.

@zpennington, I’m looking at using a creality v2.2 board (same one used in a cr10) did you have any luck getting it to work?