Do I need to reflash?

Mostly Printed CNC - MPCNC Troubleshooting
1

I’m transitioning back to 3D print mode from CNC mode. I plugged everything in(molex connectors) and the smart controller indicates the hot end is 170*. I verified that my thermocouples were in T0 and T1. Where should I look next? everything was purchased from V1 and has correctly functioned in the past.

Thank you for your help,

2

Yes you need to reflash with your thermistor enabled instead of the 999 that is in there now. I do have a 3D printer ready firmware for a few boards as well.

1 Like