Edge Lit Acrylic Lamp

One of my first projects on my Primo.
Mahogany wood base w/ engraved acrylic sheet. I have seen many of these done before, so I had to give it a try.

14 Likes

Nice work! :+1:

That came out great. I like it a lot. What bits? Speeds, etc?

I used a 1/8" Single Flute End Mill at 1000mm/min. I use the Dewalt 660 and have not implemented any spindle rpm control, so currently it is just the default 30,000rpm. I need to get more in tune with feeds and speeds, I feel like I could have ran it faster than 1000mm/min.