Electronics enclosures

I have RAMPS 1.4 board and LCD, which holders are you using or recommend?

Google Photos
Google Photos

Just printed this one up last week. Installed it Friday. I don’t have a screen on my mpcnc, just the lowrider, so I cut a piece of acrylic and superglued it to the screen mounts. I cut a couple triangles out of plywood and screwed them to the bottom of my table then screwed this case to them. The 40mm fan should keep things cool!



I just use some standard electric project boxes.
It is simple to use and cheap:

Mine is a very simple setup. The power + boards are in a drawer. Dowels keep things from moving around.