Estlcam controller setup

Mostly Printed CNC - MPCNC Troubleshooting
1

Ryan,

have looked into the controller setup of Estlcam and how it flashes the board. i used the arduino meg settings and it erased the board. i reflashed all is good.

just wanted to know if you had success with it or should i address this to chris at estlcam.

thanks a bunch

2

As far as I know you lose the LCD if you use estlcam control. I have not used it in probably 3 years.

3

ok maybe that is what happened when i saw the blank screen. i thought the firmware erased.

thank you sir.