extruder cable pinout

Mostly Printed 3D Printer - MP3DP Troubleshooting
#1

I’m troubleshooting the skip/missing filament in my prints. Have watched the gear turning, and have noticed that the skips occur when the gear is not turning. Was wondering if my cable extension wiring job did not work, so I’m about to rebuild it. At the same time I was going to add some LED’s so I can see when that motor is getting voltage command.

Does anyone have a pin-out for the cable?

#2

I just answered your other post, pretty sure that was is the issue.

#3

I’m still rebuilding the extension. Do you have a pinout?

#4

It’s a standard stepper 2 pairs of coils. You can get the coils by feel or multimeter. The ramps board is in order pair 1 ab pair 2 cd. You might want to tackle 1 issue at a time.