I see in the documentation this formula, but what is the divisible 60??
Next up is the travel feed rates. 2100/60=35mm/s, 480=8mm/s (keep the Z low)
does this mean if I put 2100 mm/s in estlcam my mpcnc will do 35mm/s, and if so, why, what is that divisible 60??
Marlin firmware expects the feed rates to be in mm/m, but estlcam works in mm/s.
1 Like
jeffeb3
(Jeffeb3)
3
Just in case that wasn’t clear. 60 seconds in a minute. Gcode expects units/min.
1 Like
thank you. Did not think about that. Got it.