Have 2 of the 4 made. Happy with how these turned out.
10 Likes
Looks good! What are they going on?
Neat! Nice having the ability to make stuff at home. 
1 Like
You made that spoiler bracket too, didn’t you? Nicely done.
Yes, another piece i finally finished this week
1 Like
Dry milling or are you spraying some WD-40 on there occasionally?
Dry.
Is that 1/4 inch single flute?
1 Like
For this particular job yes.
1 Like
Love it. That thing looks like a track monster. Mind sharing some more details on her?
1 Like
Does a bolt go through the aluminum bushing? Just curious why the aluminum bushing vs pushing the rubber grommet onto a post like a lot of exhaust hangers?
Either way, that looks great and you are giving me some encouragement to get my MPCNC dialed in so I can make cool parts for my car!
Yes, the idea is to use a bolt for this application.
Haven’t run the car yet, still building. 5.3 chevy LS with twin 3071 Garrett’s.
LS everything! I have a 2nd Gen camaro that I would love to put an LS into, but budget is usually the problem. I don’t think a pair of 3071’s are in the cards either but that sounds awesome.
What are you going to do with it when its done?
2 Likes
That looks like a lot of fun, though several runs looked like they were scrubbing off too much speed with those drifts. 
I did some track racing back when I was younger (say, in the late 1970s) but that was on a small motorcycle, which is quite the different experience.
Did you work the bevel into the tool path or was that done by hand?
Toolpath
1 Like