I am re-flashing my board after the LCD screen went blank. want to make sure I do it right. I have been following the instructions on the V1 website. and think I am ready to try it. I am using a diode laser with it and am still confused about how to change the fan Pin setting to 45 as stated on the V1 website, so that i can control the on-off and intensity. here is a screen shot of the pin layout. Do I need to change the pin from 8 to 45 or is it ok, because the Laser shows that it is controlled by pin 45?
This code stuff is still new to me.
any advise is greatly appreciated. also is there a YT video out thee of anyone going through the steps like this that I can follow?