Ok, I’m pretty sure I did something wrong…
As my FreeCAD sketch should be 210mm, but when I open it in Repetier…it’s MUCH MUCH larger than that.
I’ve attached the gcode, not sure what I did wrong.
Cam Clamp.gcode (3.8 KB)
Ok, I’m pretty sure I did something wrong…
As my FreeCAD sketch should be 210mm, but when I open it in Repetier…it’s MUCH MUCH larger than that.
I’ve attached the gcode, not sure what I did wrong.
Cam Clamp.gcode (3.8 KB)
Nevermind, didn’t export as grbl
On the upside, in ~1hr, I’ll go run this program, and see if I was able to design this entirely with freecad, including gcode generation
Lots of new improvements/stuff being added to the Path workbench in alpha builds