Just recently i have build my MPCNC.
I was amazed at how well the build went.
All parts fit together very nicely.
But now for my problem(s):
When i run the testprint, the vicious logo, i get a pretty horrible judder on the round portions of the print. I tested this print with a marker attached and the judder is very noticible.
Anyone else had this issue?
Problem 2. When i generate code from estlcam, the movement of the mpcnc is so slow, i would need a timelapse camera to see it actually moving. When i set the feedrate of the 3mm endmill to 200mm/s it actually starts doing something. I have the same problem from repetier and pronterface…
I could really use some tips!
Thanks in advance!