Loose connector on RAMBO 1.4 board

Mostly Printed CNC - MPCNC Troubleshooting
1

I ordered a RAMBO board from Ultamachine since they had them in stock 2 weeks ago. I have read a few different posts of people with a stuttering axis.

Just wondering if this is common that the female connector on the board is slightly too big? For this one connection on the board the latch connector will rock side to side a little bit.

I think I am going to change a case that i can use some type of cable strain to hold it in place since it works if it is held to one side.

Thanks in advance.

2

A dab of gluegun will secure it in place, but not solve the issue itself.

3

That’s actually the part I want to try to do when I have it in place. Maybe part of Father’s day will be getting to spend a couple hours cleaning the wiring up