Anyone use a shim so they can use 1/8" shank mills? Not finding much for 1/4" on Amazon.ca
Either 1/8" sets, or stuff with varying shank sizes.
We just had a lot of comments about the collet for Makita. Type in Makita or collets. There’s a company that sells them. https://www.v1engineering.com/forum/topic/makita-router-collet-adapter/
Phil Brooks can tell you where he bought them. We have the website link posted in the above discussion
I use a collet adapter from rockler. Works great. One with multiple “cuts” in the endmill side may improve run-out, but it works great for me.
I got an adapter from Lee valley.
Would this work? Or will it introduce too much flex?
https://www.amazon.ca/Router-Extension-Engraving-Machine-Milling/dp/B07VK2LQS6