MAME controller POC

This is just a test to make sure I have the hole spacing/size correct on the MPCNC Primo.

Also used my laser to print some text around the buttons. Looks like I need to move some of the text a bit farther away. The buttons were also a bit tight, so I’ll make the final holes a bit larger…


So we are going to have a mame cabinet at the BBQ, in the new shop…just keeps getting better.

Probably not an entire MAME cabinet. These are going to be lap units for the pi that’s plugged into the kid’s playroom TV.

Neighbor’s kid was over for dinner tonight. She said my smoked chicken is better than her dad’s. I shoulda offered to let her take the leftovers home with her :slight_smile:


Final design done. Just need to recut for the red buttons