MPCNC Improvement Suggestion

Mostly Printed CNC - MPCNC Troubleshooting
1

@Ryan as I reassemble my Burly a simple improvement occurs to me.

adding a circular “bump” to the top center point each of the corner pieces would be extremely helpful in doing the initial calibration of the machine as it would give us something to hook a tape on as we measure the diagonals of our builds. Too late for the Burly but might be a trivial add for the primo.

Just a thought.

2

The center of the top plate can move depending on how you tighten it.

Use the inner flat corner of the corner bottom, and the outer sharp corner of the bottom corner. That gives you two very fixed points.

2 Likes