MPCNC Primo UK sale

Hi all, I built this myself, used it enough to say it’s tested and works but now it’s taking up too much so its now for sale.

Roughly a 700x700mm work area. It has the Press/AMB spindle motor FME-1 1050 which I bought new.

Control board is the skr pro. Motors are new and I can’t remember their rating but it was much higher than needed.

All printed parts are in good order and many were printed at 100% infill for extra strength. Tube are 1" thick walled steel which has been blued and oiled.

The base is all 4040 extrusion and there’s obviously the additional shelf underneath. All this sits on adjustable feet.

All in all a very sturdy build.

Its located in Hampshire.

I’m asking £375.