Mpcnc skr 1.1 wiring

Mostly Printed CNC - MPCNC Troubleshooting
1

I’m sure it is simple but I can not find the answer.

I’m to the point of wiring my mpcnc and skr 1.1. I dont want to blow the steppers or the board.

I have the power supply I bought from v1. I see on the edge of the board it says motor power and just power.

Do I just run a jumper from the motor power to the power terminal and plug that in to run board and steppers?

I know the router runs on it’s own plug.

1 Like
2

Yup that’s how you do it. I cut the barrel connector of the power supply and just ran it into the power terminals. Then jumper over to the motor terminals

2 Likes
3

Thank you I didnt want to burn out board or motor figured that was it thanks for the reply