Sorry, I meant that I can’t use your lid as the base I’ve printed doesn’t have the fan mounts. Your design is good, and I’d use it but I had already printed the main base. That’s all I meant.
I’ve saved it though, may end up printing it in the future if I relocate the TFT away from the main board. Thanks again for sharing it!
1 Like
The trouble with a chart like this is that it is the unloaded rpms. The loaded rpms is lower, unless it is a brushless router.
Of course - assumed that was obvious, but probably should have mentioned it for those that wouldn’t know.
1 Like
How has the Bauer trim router held up?