Need Clarification on RAMBo Boards


I’m very excited to start building my MPCNC, but I need a little clarification on the boards. I plan on starting off simple with a 24" x 24" x 4", with no endstops, but I also want the ability to upgraded my MPCNC to use enstops without having to buy another board. From my understanding, I would have to get the RAMBo Dual Firmware & Wire Kit. If I do get this board, do I have to wire up the endstops initially, or can I leave them off until I’m more familiar with my machine?


Get the series kit, and either add the individual wire kit or buy them later. That way the board is flashed correctly and you will be ready to run ASAP. The dual kit would need firmware edits to work with no end stops.