Excited to see the crown on my new full sheet capable lowrider2! Need to address some of the low spots on the bed. The diagonals of the rectangle (1400 mm x 1360 mm) show a difference of about 1.5 mm. The ‘Z’ height shows a variation of less than 1 mm. A little bit of tuneup and I guess we are in business. Next step is to figure out how to move this monster out of my home office and into the garage 
15 Likes
Wish my first crown looked that good! Very nice! If you plan on using a spoilboard those tiny dips might be irelevent. The dips might also be from the screws on the perimeter of the table since they’re inline with the wheels. Good luck with the move!
1 Like
nice one! huge 
1 Like
Great job!
1 Like