right y axis not holding

Hi, I am having some trouble with the right side y axis on my lowrider. It moves, but it seems to lag behind the left side motor slightly, and it spins freely if not in motion. these motors are wired with the lowrider wiring kit. anyone have any thoughts about this?

I would take make sure the wiring is correct, take it off and put it back on. It is in series though so it kinda sounds more like your pulley is free spinning.

1 Like

well, now I feel dumb. I spent 3 hours looking at wiring and belts, and didnt check to see if the pulley and the motor were moving in unison. The set screws had backed themselves all the way out and were sitting on top of the motor. Thanks!

Pretty sure everyone here has had that happen at least once. Welcome to the club!