Hi everyone…
Second post here with a newbie question…
What is the size of the margins on the side of the table top that you cant cut…I guess from the center of the spindle to the edge of the table when you have the x axis at the ends …tried looking around for this but not having a lot of luck
Thanks
Way_up_north,
The LR Calculator shows a workspace size and a Table size. That should give you an idea of the “margins”.
Mike
Thanks for the quick reply…I was looking at that page but didn’t see the chart below materials…thanks for the link…much appreciated…
from that chart…looks like its 4 inches each side…
Having a cutable margin of 1/2 inch beyond your spoil board is very useful for lead ins, parking zones, etc when cutting full sheets.