Trying to return

Been having a rough winter but I’m trying to get back to the forums. Not sure what the deal is, just a bad case of the fuckits. Not too sure about this new forum layout, probably just need time to get used to it. In an attempt to try to get motivated again I was going throug my bits and receipts and found a company on ebay I
bought some nice bits from. They are


They are good bits. I in no way want to undercut Ryan but was more hoping to get him to contact these guys and maybe carry their bits? It’s tough to find 3"x3.75mm endmills for a decent price so I contacted them and they were very willing to make some for me.

2 Likes

Forgot to mention they cut their own bits in Oregon

1 Like

Do they make anything in single or dual flute, 4 flutes will not work with our high speed “spindles”.

https://www.ebay.com/str/carbidetoolsource
I think they can make nearly anything you want.

1 Like