Vinyl Cutting

Mostly Printed CNC - MPCNC Troubleshooting
1

I was a little curious about vinyl cutting… Just ordered a holder and 15 blades.

It is done basically the same way with estlcam and a pen? Except you make a cut on the outside and inside of a line instead of down then middle.

Vinyl cutting doesnt seem to be discussed on here much so I wanted to start a little convo about it.

2

I started a thread a few months ago asking about a drag knife. drag knife

I just found a good looking one to print from thingiverse and ordered bearings yesterday. I will see how well it will work.

3

Does it fit the 525 update z axis?