Walnut 3d carve

After some practice with pine boards, I dipped my toes on carving in some spare walnut boards I have lying around. The image cut was 13"x8" and almost 1" deep.

I’m using Makita 701C on the LR2 with an Elaire collet for 1/8 shanks.
Rough is 1/4 downcut endmill Feed rate 10mms 50% stepover
Fine is 1/8 ballmill Feed rate 15mms, 10% stepover

and added some shellac.

15 Likes

Very nice detail, have to get a ball mill.

Cheers!

Nice work! And I envy you having spare walnut boards lying around. :grin:

I have a garage full of walnut. For free

Dang.