I am struggling getting the series wiring correct. Both Y motors jump back and forth, not synchronized when using the smart controller advancing 10 mm each move all in the positive direction. Same problem when I tried this on the X axis. I have reversed connections without success.
- I bought the RAMBO 1.4 and series wiring kit from here. I bought the motors from Amazon, 17HS19-2004S1.
I have the RAMBO 1.4 kit, MPCNC813FullRAmbo_GLCD_T8 –16T Pulleys, T8 Leadscrew, Full Graphic LCD, with end stops (not connected yet)
- I planed to use end stops, but they are not connected yet, but wire NC
- PC windows 10
I uploaded a YouTube video,
Photos attached of wiring.
Insight or help would be appreciated.