XY_C_Burly print on Anet printer goes to idle half way into print

We are trying to print the STL file for the XY_C_Burly part for the MPCNC. After the print got around 30-40% complete, the printer went to Idle and then the stepper automatically disabled. The file in Cura estimated it to be a 9.25 hour print. 55% infill density. 210 degree build temperature. 2mm layer height.


Any ideas why a print like this would go idle? We are going to try it again, suspecting something might be wrong with the gcode file??.

Try rotating the part 90 degrees and re-slicing it.

1 Like