+================================================ + + G Code - Vectric machine output configuration file + +================================================ + + History + + Who When What + ======== ========== =========================== + Tony 02/08/2005 Written + +JeffH 20/06/2019 Feed move G01 added for Estlcam + M6 deleted from Header after T1 +================================================ POST_NAME = "Estlcam GCode (mm) (*.tap)" FILE_EXTENSION = "tap" UNITS = "MM" +------------------------------------------------ + Line terminating characters +------------------------------------------------ LINE_ENDING = "[13][10]" +------------------------------------------------ + Block numbering +------------------------------------------------ LINE_NUMBER_START = 0 LINE_NUMBER_INCREMENT = 10 LINE_NUMBER_MAXIMUM = 999999 +================================================ + + Formating for variables + +================================================ VAR LINE_NUMBER = [N|A|N|1.0] VAR SPINDLE_SPEED = [S|A|S|1.0] VAR FEED_RATE = [F|C|F|1.1] VAR X_POSITION = [X|C|X|1.3] VAR Y_POSITION = [Y|C|Y|1.3] VAR Z_POSITION = [Z|C|Z|1.3] VAR X_HOME_POSITION = [XH|A|X|1.3] VAR Y_HOME_POSITION = [YH|A|Y|1.3] VAR Z_HOME_POSITION = [ZH|A|Z|1.3] +================================================ + + Block definitions for toolpath output + +================================================ +--------------------------------------------------- + Commands output at the start of the file +--------------------------------------------------- begin HEADER "T1" "G00 [ZH]" "G00 [XH][YH]" +--------------------------------------------------- + Commands output for rapid moves +--------------------------------------------------- begin RAPID_MOVE "G0 [X][Y][Z]" +--------------------------------------------------- + Commands output for the first feed rate move +--------------------------------------------------- begin FIRST_FEED_MOVE "G01 [X][Y][Z][F]" +--------------------------------------------------- + Commands output for feed rate moves +--------------------------------------------------- begin FEED_MOVE "G01 [X][Y][Z]" +--------------------------------------------------- + Commands output at the end of the file +--------------------------------------------------- begin FOOTER "G00 [ZH]" "G00 [XH][YH]"