600x400 Primo Build in Indonesia

[nazmy25 (Nazmy)]

after 2 weeks started to build this, finally almost finished my first mpcnc, with some trouble and struggle, there are some parts that quite difficult to get,

at least it can work, havent trying to cut something maybe next day…

i am not an engineer neither programmer, just a junior highschool teacher in economic study
so i need lesson, suggestion and tutor from expert from this group,

sorry for my bad english

[jeffeb3]

Looks great. Welcome to the crew.

[nazmy25 (Nazmy)]

thanks @jeffeb3 i’ll do my best

[Hart3d (Hartono 3d)]

Success @nazmy25 . I am planning to build it too. I start learning it one by one. What diameter of stainless steel do you use?

[nazmy25 (Nazmy)]

thanks @Hart3d. im using stainless steel tube with OD 1 inch or 25,4 mm

[Hart3d (Hartono 3d)]

Noted, thanks @nazmy25. I can start sourcing for the good straight one.