Angled Pocket?

Mostly Printed CNC - MPCNC Advice
1

Is there any way to setup an angled pocket in ESTLcam so it gets deeper from one side to the other using a V-bit?

I’m starting on the Open Source Beehive:

https://www.osbeehives.com/

It calls for an angled pocket for the entrance for the bees and another in the roof. I don’t know how to program that.

Anyone done this project? I’m going to have some other questions because the colors in the instructions aren’t clear and I don’t have enough experience to know how to open any of the models and take them apart to inspect the parts.

I don’t have a Low rider (yet) so I’m also going to have to break it up into 24x24" pieces. More waste, but it should be able to be done.

Many thanks.

2

Yup, it is best to have a bit at the same angle as the cut needs to be, the just follow the cut path and it leaves you an angle.