I have an MPCNC Primo, DW611 and am using a 1/8" ball nose bit from V1 for this. I’m trying to carve the spoon you see in the attached photos (grabbed the model from a kind soul on Reddit).
The issue I’m experiencing is collisions between my holder/shaft and the stock during simulation. My stock is somewhat deep and my bit is not but I think it should be able to theoretically carve itself down to where I want it to go. How does Fusion’s CAM allow for the presence of the shaft/holder as it carves items into deeper stocks? I thought that is what the Shaft & Holder mode is under the tool tab but I’m not sure what I’ve done wrong.
I’ve attached photos of the model, an example of the collision location and what my parallel toolpath tabs currently show. The six holes you see on the sides are used with dowels to flip the stock over and continue on the backside as a two-sided carve.
If you see anything I’m doing wrong, please let me know. Thank you!