Hi,
here is my new Toy. Not 100% ready, but the first crown was fine…
work area: 2500mm x 1100mm
my plane-milled sacrificial plate is a little smaller
Controller Board is Open CNC Shield incl Autosquaring.
direct control via Estlcam
Why is it that German builds always seem to have nice, industrial-grade control boxes housing their electronics, and American builds have cereal boxes and duct-tape holding a rats nest of wires to one leg of a repurposed picnic table from a condemned pre-school? Is industrial design part of the Teutonic gestalt? Has the “Get 'er done” mentality ruined our ability to engineer our way our of a wet paper bag? Sure, we put a man on the moon, but let’s be honest, we did it with German rocket scientists…
Yes, i use only ESTLCAM. I ve no Display or SD Card Slot, use only my PC…
Mir wäre das viel zu umständlich, immer den GCODE per SD Karte auf die
Fräse zu bringen. Das Open CNC Shield ist Quasi eine Upgrade
des Tillboards (-> MPCNC-Nano-Estlcam-Shield). bzw eine Zusammenfassung des Tillboards und des Tillboard Extension Boards