From 3D printing, I’m very familiar with Marlin’s Baby Steps feature.
On my LowRider 2, Marlin “Baby Steps” feature is not working with my BTT SKR + BTT TFT combo.
I’m using the suggested default firmware, without dual endstops.
Is this feature supposed to work? I get an error message about an unknown command whenever I try it.
I took a look at a version of V1 maintained firmware and found that baby stepping was not enabled. You can search in configuration_adv.h for this line:
//#define BABYSTEPPING
In theory, you could uncomment this line, recompile and reflash to get baby stepping. I don’t know if ther are any CNC ramifications to enabling this feature.
You are the man. Thanks. Will look into doing that.