SOLD!
I purchased the complete MPCNC parts bundle along with extras about 9 months ago and printed all of the the parts. However, I don’t have time to complete this project. The MPCNC is still in the original box that it was shipped in. All of the 3D printed parts are orange and were printed at high resolution (very nice finish).
I’m selling the following complete kit
- Mostly Printed CNC Parts Bundle - With 6A / RAMBo Dual Firmware & Wire kit
- Full Graphic Smart Controller, Big
- 1/16" 2 Flute Carbide EndMill
- GT2 6mm Belt × 4
- Drag Knife / Vinyl Cutter
- Emergency Stop Button
- 1/8" 2 Flute Carbide EndMill
- 1/8″ 2 Flute Carbide Long
- 1/8" 45 Degree Carbide V-Bit
- 3D Printed MPCNC parts (for 3/4″ EMT conduit)
Thanks,
Jeremy