I’m not sure if I missed the part where you send power to the stepper motors on the board. Am i supposed to just splice both sets of red and black wires and run them to the power supply, i know that seems obvious but i dont want to ruin anything
I’m not sure if I missed the part where you send power to the stepper motors on the board. Am i supposed to just splice both sets of red and black wires and run them to the power supply, i know that seems obvious but i dont want to ruin anything
Once again thank you!
Apologies for resurrecting an old thread but I notice that the V1 documentation shows dedicated wires going to the motor power terminals.
Yes they do
